You gotta remember that if you replace an OM-4 board with a board from a
4T(i), you do not get an equivilant 4T when you are done! Just a thought if
someone is not aware. Paul.
Mr. Chris Lee wrote:
> On Sun, 22 Mar 1998 11:11:37 JST, you wrote:
>
> >I checked the cost of the replacement at the Olympus official service
> >center in Tokyo by phone the other day. The circuit board replacement
> >should be accompanied with its overhaul. The cost of the board is not
> >so expensive, about $50-60US. But the overhaul cost is far more, about
> >$120-125US. So, overall cost will be about $170-185.
> >I think this cost is obviously less than that of the used OM-4Ti.
> >
> >The cost may be different in US. So, this is the case in Japan.
> >Anybody would like to buy a RT ticket?
> >
> >Toshi in Kyoto/Japan
>
> Toshi
>
> Dose the Olympus service center in Tokyo accept camera sent from
> overseas?
>
> My OM-2n needs repair, however I am not satisfied with the serivce of
> the Olympus agent in Hong Kong.
>
> (Does anybody know a good repair shop in Hong Kong?)
>
> Thanks in advance.
>
> Regards,
> Mr. Chris Lee
>
> Remove NOSPAM. form reply address to reply
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|