In a message dated 98-09-16 03:43:36 EDT, you write:
<< On the OM bellows at the camera body end, what direction should the release
knob be sticking out, mine is on the top side. Presumably this is wrong as
the camera then fits at an angle, though it works otherwise..
It was acquired like this, can i just unscrew the camera attachment ring
(from the bellows) then rotate it to the left. Its held on by 3 screws,
will it reattach firmly.
Thanks >>
There's an easier way. Use camera mount clamping screw on the right side of
the rear standard as you look forward. As a matter of fact, the bellows
instructions say to remove the entire mount and attach the camera body mount
to the OM body just like a lens. Then attach the mount/camera combination to
the bellows and tighten it in place with the clamping screw. There is no need
to remove the 3 screws as the entire camera mount rotates.
Warren Kato
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|