Olympus-OM
[Top] [All Lists]

Re: [OM] OM-4 Meter Reading

Subject: Re: [OM] OM-4 Meter Reading
From: "Tom Trottier" <infoanim@xxxxxx>
Date: Sat, 29 May 1999 00:24:23 -0400
Folks,
Moving contacts repeatedly is a common practice to clean oxidation off 
them, e.g. stereo controls,...

Has anyone tried one of the spray deoxidisers? e.g. DeoxIT D5? 
Especially, does it dissolve anything else beside the oxide?

Tom

> Date: Fri, 28 May 1999 08:27:49 -0400
> From: "John Hermanson" <omtech@xxxxxxxxx>
> Subject: Re: [OM] OM-4 Meter Reading
> 
> The grease is the type that olympus supplies to me.  It is the correct
> type, whatever it is.  Application requires enough grease but not too much
> ;-)
> 
> John
> - ----------------------------------------------------------------
> Camtech / Olympus Service since 1977
> - --------------------------------------------------------------
> - ----- Original Message -----
> From: Tom Curlee <t_curlee@xxxxxxxxxxx>
...
> > >I found the dirty resistor board problem show up in another way in my
> > >4T (which I had not used for awhile).  I had the camera set to MANUAL
> > >but
> the
> > >shutter speeds  and meter display were still in the AUTOMATIC mode.
> > >After racking the Auto / MAN switch back & forth about 30 times, the
> camera
> > >returned to   manual.
> > >
> > >John
> > >----------------------------------------------------------------
> >
> > John:
> >
> > I assume that the dielectric grease you speak of is the silicone type
> (clear
> > with a very slightly milky haze).  What do you clean the resistor board
> with
> > (alcohol)?  How much grease is enough, or perhaps, how much is too much?
> I
> > wonder if more grease is better than less, up to a point (don't want
> grease
> > oozing out of the asa mechanism down into the rest of the camera,
> > running off the mirror, etc.)
> >
> > Thanks, Tom
------------------
From: Tom Trottier, President, ACT Productions Inc.
infoanim@xxxxxx                   http://www.act.ca
+1 613 594-4829                 fax +1 613 594-8944
199 Holmwood Ave,  Ottawa, Ontario, Canada  K1S 2P3
"Make it as simple as possible, but no simpler" - Einstein

< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz