Olympus-OM
[Top] [All Lists]

Re: [OM] Re: olympus-digest V2 #1894

Subject: Re: [OM] Re: olympus-digest V2 #1894
From: clintonr@xxxxxxxxxxxxxxxx
Date: Fri, 13 Oct 2000 16:43:29 -0500
Alan!

Put down that spray!  There's no way you can get to the ASA's VR without
taking the top cover off of your OM-2s - and that's the culprit.  If you
do try the spray, it's going to get into the finder and other delicate
mechanisms, and _then_ you'll be sorry!  The ASA needs to be cleaned and
coated with a protective coating to prevent the erratic display.

The OM-2 and OM-2n don't have a VR coupled to the aperture ring - it's a
mechanical device that physically alters the galvo's position.  I
suspect that the wire going to the meter has broken and makes
intermittant connection (or, in this case, intermittant
_dis-connection_!).


Alan Magayne-Roshak wrote:
> 
> I'm having an annoying problem with my OM2S, and am curious if anyone else
> has had this too.  I think it might be dirty contacts in the ISO dial.
> When the camera is on auto, much of the time it beeps and indicates "OVER",
> even though I have the aperture set where it couldn't possibly be too large
> an f/stop.  If I push on the ISO/Comp dial and turn it back and forth to
> the extremes a few times, the camera gets normal and the readout gives the
> correct reading (which is about three stops different than the erroneous
> warning).  I'm wondering if some sort of TV tuner cleaner could be sprayed
> (gently!) into the ISO dial.
> Anybody run into this?  It drives me crazy.
> 
> I'm also wondering if my OM2n has a similar problem with the resistor(?)
> that moves with the f/stop ring.  At intermediate settings the meter needle
> goes crazy and jumps around erratically.  Above and below that range, it
> settles down and  moves normally.
> 
> Any feedback would be appreciated.  I seem to have bad luck with bodies; my
> favorite, the OM4, now has a dead circuit, but then I bought it used and it
> always was a little goofy.
> 
> Alan Magayne-Roshak
> 
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >

< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz