Olympus-OM
[Top] [All Lists]

Re: [OM] winder2 problem

Subject: Re: [OM] winder2 problem
From: clintonr@xxxxxxxxxxxxxxxx
Date: Fri, 08 Nov 2002 14:54:50 -0600
First, try lifting the selector knob and moving it slightly off the
"sequence" mark, first one way then the other -- it could be that the
switch is a tad off, or there may be a "bad spot" on the contact pad
inside.  If that's not it, you may have to drop the lower half of the
winder and check the switch inside -- look for a loose wire to the sequence
switch, bent contacts, corrosion, whatever....

Mike wrote:

> Why would a winder 2 not work in sequence mode? It works fine in single
> mode and acts like it's in single mode when switched to sequence mode,
> i.e. it fires the shutter and advances one frame only.


< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz