Olympus-OM
[Top] [All Lists]

Re: [OM] Winder 1 service manual or schematic needed

Subject: Re: [OM] Winder 1 service manual or schematic needed
From: Michael Darling <miked2002@xxxxxxxxxxxxx>
Date: Sat, 8 Mar 2003 00:16:02 -0500
Whatever was wrong doesn't seem to be a permanent problem. The winder is working fine now, but I did reproduce the problem once. After shorting the contacts I measured about 4.5-5VDC on the contacts, and shorting them or mounting a camera body caused the motor to run continuously without tripping the shutter. Once it 'reset' itself and began operating normally again, I measured about 20mVDC across the contacts.

At least its working now... I don't think I'm going to mess with it much more.

Thanks to all for the help, links, schematics, etc!

Mike



On Wednesday, February 19, 2003, at 12:55 AM, clintonr@xxxxxxxxxxxxxxxx wrote:

Does the motor keep running but nothing happens, or is the shutter
winding and firing non-stop?  If the former, I would suspect that the
rubber ring inside between the wind gears has dissolved -- that would
require removing and disassembling the wind mechanism to replace the
ring.  If the latter, I would check for short circuits, or perhaps one
of the traces on the circuit has been cut by improper assembly (long
screw in wrong hole, etc.).


< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz