Can the typical badger airbrush be used for lacquer based paints? As against
water based ones?
----- Original Message -----
From: "John Hermanson" <omtech@xxxxxxxxx>
To: <olympus@xxxxxxxxxxxxxxx>
Sent: Tuesday, June 10, 2003 9:02 PM
Subject: Re: [OM] Getting rid of engraving (was KEH Bargain = silvernose?)
> I checked my parts lists but I don't think I have any CB1289 (new filter
> ring silver edged 100 f2.8)
> _________________________________
> John Hermanson www.zuiko.com
> Camtech, Olympus Sales & Service since 1977
> 21 South Lane, Huntington NY 11743-4714
> 631-424-2121 For Free Olympus manuals,
> please call 1-800-221-3000
> _________________________________
> ----- Original Message -----
> From: <Doggre@xxxxxxx>
> To: <olympus@xxxxxxxxxxxxxxx>
> Sent: Tuesday, June 10, 2003 4:52 AM
> Subject: [OM] Getting rid of engraving (was KEH Bargain = silvernose?)
>
>
> >
> > One method would be to carefully sand down the high spots (and ONLY the
> high
> > spots) where the engraving has raised the metal (220 grit if deeply
> engraved,
> > followed by 400 grit, or just 400 grit, if lightly engraved). Then
prime,
> > sand, reprime and resand as necessary until smooth and the engraving is
no
> longer
> > obvious, then repaint. Done well with an airbrush, it should look like
> new.
> >
> > Rich
> >
>
>
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|