Olympus-OM
[Top] [All Lists]

[OM] Fw: Galvanometer in OM-1(n)

Subject: [OM] Fw: Galvanometer in OM-1(n)
From: "John Hermanson" <omtech@xxxxxxxxx>
Date: Mon, 7 Mar 2005 08:48:06 -0500

> Most of this is covered in Clint's note. Mechanical core of meter is the
> same, but you may have to swap over the small gear.  Also, the meter from 
> the 1N may have to have it's needle rebent to match the config of the old 
> one.
>
> John Hermanson
> Camtech Photo Services, Inc.
> 21 South Lane, Huntington, NY, 11743-4714,
> 631-424-2121, www.zuiko.com
> Olympus OM Service since 1977
> <:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:>
> ----- Original Message ----- 
> From: "Ing. Radovan Faltus" <faltusr@xxxxxxxxx>
> To: <olympus@xxxxxxxxxx>
> Sent: Saturday, March 05, 2005 12:45 PM
> Subject: [OM] Galvanometer in OM-1(n)
>
>
>>
>> Dear fellows,
>>   would you know if it's possible
>> to use OM-1 dedicated galvanometer (spare part)
>> for OM-1n? Are there any changes in construction
>> which don't allow this?
>> What about matter of it's own sensitivity, is
>> that necessary recalibrate with changing resistor net
>> or just mechanically?
>>
>> Thanks,
>> Radek
>>
> 



==============================================
List usage info:     http://www.zuikoholic.com
List nannies:        olympusadmin@xxxxxxxxxx
==============================================

<Prev in Thread] Current Thread [Next in Thread>
  • [OM] Fw: Galvanometer in OM-1(n), John Hermanson <=
Sponsored by Tako
Impressum | Datenschutz