Olympus-OM
[Top] [All Lists]

Re: [OM] T10 mounting thread size?

Subject: Re: [OM] T10 mounting thread size?
From: "Darin" <d.rhein@xxxxxxxxxxx>
Date: Sat, 3 Jan 2009 14:22:45 -0800
Huray! I finally got it. Rubber bands and a very, very gentle grip did the 
trick.

Thanks for all the help guys!

Darin


----- Original Message ----- 
From: "Chuck Norcutt" <chucknorcutt@xxxxxxxxxxxxxxxx>
To: "Olympus Camera Discussion" <olympus@xxxxxxxxxxxxxxxxx>
Sent: Saturday, January 03, 2009 1:14 PM
Subject: Re: [OM] T10 mounting thread size?


>I hadn't thought about that but Moose has a good point here.  Since you
> clearly have access to the front edge of the ring a simple friction tool
> may work best.  I'm thinking of a thin rubber sheet (like the jar
> openers or shelf liners I mentioned earlier) sandwiched between the
> front edge of the ring and a small block of wood a bit bigger than the
> diameter of the ring.  Press down and rotate.  Just like using a
> friction tool to remove the "name ring" on the front of a lens.
>
> Chuck Norcutt
>
> Moose wrote:
>
>>
>> I have usually found that applying pressure only on the front edge/rim
>> of the ring, perpendicular to the plane of it, and none at all against
>> the sides, will loosen a ring that is otherwise apparently really stuck
>> hard. It's can be quite amazing how a little persuasion, with a bit of
>> jiggling, rocking, etc., can gently remove a ring where brute force
>> applied in another direction cannot. This may apply to filters, as well.
>>
>> Moose
> -- 
> _________________________________________________________________

-- 
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/

<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz