You could also remove the resistor between board and galvanometer and
replace with the appropriate potentiometer.
___________________________________
John Hermanson | CPS, Inc.
21 South Ln., Huntington NY 11743
631-424-2121 | www.zuiko.com
Olympus OM Service since 1977
Gallery: www.zuiko.com/album/index.html
John Hermanson wrote:
> Some FT boards have a trimmer pot, others are adjusted by:
>
> 1) note the iso you are shooting at, also note meter error.
> 2) lift and turn shutter speed / iso knob until meter reading is correct.
> 3) after peeling leather up on iso knob side, loosen top screw most of
> the way. Loosen bottom screw a little.
> 4) GENTLY lift top edge of shutter speed dial / iso knob plate assembly
> so it separates from body and inner gear which connects it to the meter.
> While knob is separated from this gear, Gently lift and turn iso back
> to the original setting you were using.
> 6) re-seat shutter speed / iso knob assembly, gently rock knob back and
> forth to be sure gear has re-seated.
>
> ___________________________________
> John Hermanson | CPS, Inc.
> 21 South Ln., Huntington NY 11743
> 631-424-2121 | www.zuiko.com
> Olympus OM Service since 1977
> Gallery: www.zuiko.com/album/index.html
>
>
> iwert bernakiewicz wrote:
>> hello,
>>
>> i there anyone on the list who can "enlighten" me on the callibration
>> of a pen FT light meter?
>>
>> The meter seems to work well but is 2 stops off...
>>
>> Best regards,
>>
>> Iwert.
--
_________________________________________________________________
Options: http://lists.thomasclausen.net/mailman/listinfo/olympus
Archives: http://lists.thomasclausen.net/mailman/private/olympus/
Themed Olympus Photo Exhibition: http://www.tope.nl/
|